Repair Riot

Refrigerator Not Cooling or Freezing

When your house revolts, we help you restore order.

On this page

Quick answer

Check the temperature settings, ensure the condenser coils are clean, and verify the door seals are tight. If the fridge still doesn't cool, the evaporator fan or defrost system may be faulty.

Confirm the symptom

Tools and prep

Step-by-step troubleshooting

  1. Check Temperature Settings
    Do: Verify the temperature settings on both the fridge and freezer compartments.
    Observe: Settings are correct (35–40°F for fridge, 0°F for freezer).
    Means: Incorrect settings may prevent proper cooling.
    Next: Adjust settings if needed and wait 24 hours to see if cooling improves.
  2. Inspect Door Seals
    Do: Close the door on a piece of paper and try to pull it out.
    Observe: Seals are tight and don't let the paper slide out easily.
    Means: Loose or damaged seals let cold air escape.
    Next: Replace seals if they are damaged or not sealing properly.
  3. Clean Condenser Coils
    Do: Locate and clean the condenser coils (usually at the back or bottom of the fridge).
    Observe: Coils are free of dust and debris.
    Means: Dirty coils reduce cooling efficiency.
    Next: Allow coils to dry completely before plugging the fridge back in.
  4. Check for Frost Buildup
    Do: Inspect the evaporator coils inside the freezer for excessive frost.
    Observe: Evaporator coils are not covered in thick frost.
    Means: Frost buildup can block airflow and prevent cooling.
    Next: If frost is present, check the defrost system components.
  5. Test Evaporator Fan
    Do: Listen for the evaporator fan running when the freezer is operating.
    Observe: Fan is running quietly and continuously when the freezer is on.
    Means: A faulty fan can prevent cold air from circulating.
    Next: If the fan is not working, it may need to be replaced.
  6. Inspect Defrost System
    Do: Check the defrost timer, heater, and thermostat for proper operation.
    Observe: Defrost system components are functioning correctly.
    Means: A malfunctioning defrost system can cause excessive frost and poor cooling.
    Next: Replace any faulty defrost components as needed.
  7. Check for Level Placement
    Do: Ensure the refrigerator is level on the floor.
    Observe: The fridge is stable and does not rock side to side.
    Means: An uneven fridge can affect door seals and cooling performance.
    Next: Adjust the leveling legs if the fridge is not sitting evenly.
  8. Verify Airflow Vents
    Do: Check that the vents between the fridge and freezer are not blocked.
    Observe: Air can flow freely between compartments.
    Means: Blocked vents prevent cold air from reaching the fridge.
    Next: Clear any obstructions from the vents and ensure proper airflow.
  9. Test Compressor
    Do: Listen for the compressor to start and run when the fridge is on.
    Observe: Compressor is running and producing a normal hum.
    Means: A failed compressor will prevent the fridge from cooling.
    Next: If the compressor is not working, professional repair or replacement may be needed.

Common causes

CauseLikelihoodDifficultyPart often needed
Dirty condenser coils
Dust and debris reduce heat dissipation, causing the fridge to overheat and undercool.
CommonEasyNone
Faulty evaporator fan
The fan circulates cold air; if it fails, the fridge won't get cold.
CommonMediumEvaporator fan motor
Defrost system malfunction
A faulty defrost timer, heater, or thermostat can cause frost buildup and poor cooling.
CommonMedium–HardDefrost timer, heater, or thermostat
Incorrect temperature settings
Settings that are too warm will prevent proper cooling.
SometimesEasyNone
Worn door seals
Loose or damaged seals let cold air escape, reducing efficiency.
CommonEasyDoor gasket
Blocked airflow vents
Obstructions prevent cold air from reaching the fridge compartment.
SometimesEasyNone
Failed compressor
The compressor is the heart of the cooling system; if it fails, the fridge won't cool.
RareHardCompressor
Refrigerant leak
Low refrigerant levels prevent proper heat transfer and cooling.
RareHardProfessional repair
Uneven fridge placement
An unlevel fridge can affect door seals and cooling performance.
SometimesEasyNone
Overloading the fridge
Too many items block airflow and prevent proper cooling.
SometimesEasyNone

Parts matching

If you need to replace parts, match these common components to your refrigerator model:

Always refer to your owner's manual for specific part numbers and installation instructions.

When to call a professional

FAQ

How often should I clean the condenser coils?

Clean the condenser coils every 6–12 months to maintain optimal cooling performance.

Can I replace the evaporator fan myself?

Yes, but ensure the fridge is unplugged and follow the owner's manual for proper installation.

Why is my fridge making a clicking noise?

A clicking noise could indicate a faulty defrost timer or relay switch.

Is it normal for the fridge to run constantly?

No, a fridge should cycle on and off. Constant running may indicate a cooling issue.

How do I know if the defrost system is working?

The defrost system should melt frost during the defrost cycle. If frost builds up excessively, the system may be faulty.

Can a refrigerator with a bad compressor be repaired?

Replacing a compressor is expensive and often not cost-effective; consider professional evaluation.